In a typical home, lighting accounts for around 10-20% of the electricity bill, but if you change your old-fashioned incandescent lighting to more energy-efficient options, you can lower this proportion and save on your overall energy bill. Installing five low energy light bulbs will cost about £15 and could save you as much as £32 a year.
Take back control of your energy bills with uSwitch!
We make it easy to compare and save up to £512
Read our guide to find out more about how to make changes to your lighting to save on your electricity bill, or read our top tips for a quick summary.
Lighting: eight top tips to save on your energy bills
Only turn the lights on if you have to. Daylight is the most energy-efficient form of light.
Turn off lights when you leave a room, unless you are going back within a few minutes.
Choose low energy (compact fluorescent) lighting, there is a bulb available for virtually every situation and to suit all tastes.
Avoid installing halogen lighting, especially the low voltage types which go in recessed fittings in ceilings and walls.
Install low energy bulbs of the correct light output - to match the output you had with traditional lighting, simply divide by five to calculate the low energy equivalent.
Fluorescent tubes are energy-efficient, and cast the safest light in kitchens.
Use side lights with low energy bulbs installed in them if you are stuck with fixed halogen lights that are difficult to replace.
Start to think of light bulbs as one-off purchases that last many years, like a lamp itself, rather than something you simply throw away after a short time.
What is the best form of lighting to use?
This is a bit of a trick question - the best and most energy-efficient form of lighting is actually daylight.
Make the most of it by drawing back curtains and if possible net curtains too, cleaning your windows and decorating your rooms in light colours. If you are truly enthusiastic about maximising daylight, a dark corner of your home might benefit from a light-pipe, which funnels light from a roof down a long tube.
If you are refurbishing your home, you could think about opening it up from a light perspective, by installing indoor windows, glass doors or glass bricks.
As well as being energy-efficient and free, daylight also tends to make people feel good.
Why should I avoid using traditional incandescent light bulbs in my home?
The incandescent, tungsten, or filament light bulb as it is known, isn't energy-efficient at all. It converts very little of the electricity it uses into light, most of it is wasted as heat, which also tends to shorten the life of light fittings and shades.
The other downside of an incandescent light bulb is its short life. The typical incandescent light bulb (known as GLS - or general lighting service) will last 1,000 hours or one year's typical use. Turning them on and off regularly shortens their lives even more.
Incandescent light bulbs are being phased out by the end of 2011 under a government initiative.
What is the difference between a low energy and a compact fluorescent light bulb (CFL)?
There is some confusion about this because compact fluorescent light bulbs (or CFLs) have typically been referred to as 'low energy light bulbs' by retailers. However, the reality is that there are a number of different kinds of low energy light bulbs available, including CFL and LED light bulbs.
Just to make things more confusing, some rather inefficient lighting products, such as traditional incandescent and halogen bulbs, come in 'low energy' versions. However, these are nowhere near as energy-efficient as compact fluorescent bulbs, and they have short lives too.
Energy-saving light bulbs seem so expensive: will they really save me money?
In short, yes.
One of the key reasons why more people haven't switched to energy-efficient lighting is because they see them as more expensive. Often people base this assessment on the purchase price only, rather than the whole-life cost of a light bulb. Incandescent bulbs have to be replaced much more often, and they use five times the electricity of low energy light bulbs, which means they actually work out to be very expensive.
As CFLs have become more popular, the costs have come down significantly. At around £3 or less for good quality versions of common bulb types, they soon pay for themselves. Savings will be in the region of £6 a year for average use of a bulb, so it's easy to see that the upfront cost will be recovered within a few months.
What about ordinary fluorescent lighting, I've heard it uses a lot of energy when it's switched on, is this true?
Old-style fluorescent tubes are a source of efficient and effective lighting in homes, and are most commonly found in kitchens. Smaller strips are sometimes also used for giving extra light on work-surfaces partially covered by kitchen cupboards. Fluorescent tubes are also found in garages, lofts and bathrooms.
There's actually no foundation to the belief that fluorescent tubes use a huge amount of electricity when they are switched on. The extra electricity used is negligible; if this wasn't the case, it would blow your fuses and trip switches.
How long do old-style fluorescent tubes last?
Fluorescent tubes do have a limited life, although this will be several years. If there are signs of flicker, or a tube looks as though it has failed, it is worth checking if you need a replacement 'starter' before you consider replacing the tube. A starter is a small cylinder with two small T shaped pins protruding from one end. It is mounted in a socket on the side of the lamp housing - it may not be immediately obvious, as it does not protrude much, and its end surface is only about the size of a penny. Starters only cost a couple of pounds and it is always worth keeping a spare one.
Why do halogen light bulbs use so much energy?
Halogen light bulbs are more efficient than incandescent light bulbs on a like for like basis. But, unfortunately, this is often cancelled out because people use more of them. There has been a trend to place a number of halogen lights in a row along a ceiling, partly for design reasons, but also because of the directionality of the light produced, several lights are normally required. The overall energy consumption can therefore be greater, even though a typical halogen bulb might have a maximum of 40 watts power, compared to a 60 or 100 watt incandescent, with the result that your electricity bills may be higher if you have halogen lighting.
What types of halogen bulbs are there?
Halogen bulbs tend to come in two types.
There are the low voltage (but not low energy) bulbs recessed into ceilings (known as 'down-lighters') and walls. These are usually MR16 bulbs. These have a hidden transformer, stepping down from mains 230 voltage to the 12 volts of the bulbs; they are 'reflectors', giving directional light.
There are also halogen bulbs that are put in open mounts, typically GU10 mounts, and these are normally found in kitchens, on spotlight ceiling bars, or ceiling plates. Although popular, they are not necessarily the most practical, as they cast shadows and generate a lot of heat. However, it is possible to buy compact-fluorescent ('low energy') bulbs to replace these, giving a more energy-efficient and less directional light, which is more practical. You can also fit LED replacements, although these are generally more expensive and do not cast as good a light as the compact fluorescent bulbs.
The G9 variety of halogen bulbs, which are very small, are often used in decorative light fittings. There are now LED energy-efficient alternatives for these, which although they cost more initially, they save on energy and last a lot longer, making them cheaper in the long run.
How does the life of a halogen bulb compare with that of a compact fluorescent bulb?
Halogen bulbs typically have a 2,000 hour (or two year) life, only a fraction of the life of a compact fluorescent bulb, which typically lasts 6-15 years (or 6,000 to 15,000 hours).
If you can't replace your halogen lighting, then it is best to make use of free standing lighting like lamps as much as possible, and fit energy-efficient bulbs in these.
Why are compact fluorescent light bulbs (CFLs) so energy-efficient?
Compact fluorescent light bulbs are much more efficient because they don't produce so much waste heat. They use only a fifth of the electricity, in other words they are 400% more efficient. In terms of energy efficiency, switching to compact fluorescent light bulbs has more impact than anything else you can do. Nothing else comes anywhere near to this level of saving and improvement in efficiency. Not to mention the fact that your light fittings and shades will last longer because they won't be exposed to so much heat.
What types of compact fluorescent light bulbs (CFLs) can I buy?
CFLs are now available in a wide variety of powers, mounts (caps) and shapes. Reflector bulbs, for spot lamp applications, are also now commonly available. The caps that low energy bulbs are available in include bayonet (BC or B22), small bayonet (SBC or B15), standard Edison screw (ES or E27), small Edison screw (SES or E14), and GU-10 (to replace many non-recessed kitchen halogen bulbs). However, they are not available to replace 'low voltage' halogen lights, as used in housings recessed into ceilings.
Compact fluorescent bulbs come in a variety of shapes, including uncovered, covered and reflector types. Uncovered shapes include curly (or spiral) and the very common stick varieties. Covered shapes include the conventional pear shaped (or 'GLS'), golf-ball, globe, and candle. Covered shapes tend to have greater physical strength, as the fluorescent tube itself is hidden behind a layer of stronger glass. However this reduces their energy efficiency a little, sometimes being B rather than A rated (for comparison, incandescent bulbs are G rated). So, you should be able to find one to work with your existing light fittings.
I've just moved into a new-build home and the light sockets are different to the ones I'm used to. Why is this?
Under building regulations, new homes, and extensions to existing homes, must ensure that around 30% of the light sockets fit energy-efficient bulbs only. This means you can't use conventional bayonet and screw mounts at all - they're not compatible.
A compact fluorescent light bulb normally has its electronics embedded in its base, but the specialist 2-pin and occasionally 4-pin light fittings have the electronics in the socket, so when the bulb needs replacing, it is only the tube itself that needs to be replaced (usually with a PLS lamp). However, the range of energy-efficient bulbs available to work with this type of light fitting, especially as regards power levels, is limited.
I've heard that compact fluorescent light bulbs (CFLs) take a long time to light up and that the light is very white, is this true?
One reason for people's reluctance to use low energy bulbs is because of their experiences with early models. These took longer to light up to their full brightness, and they cast a very white light, which wasn't to everyone's taste, plus they were also bulky. But all these issues have been addressed.
CFLs vary in their 'colour temperature', which is expressed in degrees Kelvin (K). Higher temperatures mean whiter light, cooler temperatures mean yellower light. People's tastes vary regarding colour temperature, some finding the more yellowish colours warmer and more welcoming. Some low energy bulbs have a colour temperature which is 'daylight balanced', and this is thought to help people who suffer from seasonal affective disorder (SAD), also known as winter depression, which is due to lack of daylight in winter.
The reality is that CFLs have moved on considerably since they were first introduced, and they now offer a range of lighting options.
Can I use a dimmer with compact fluorescent lamps, and what about time switches and light sensitive switches?
Instructions for some time switches and light sensitive switches sometimes allege that compact fluorescent light bulbs can't be used with them. In most instances, this isn't the case.
This advice may have arisen because some early CFLs took a long time to light up, which may have disrupted any light sensitive circuitry in the switching device. The best way to find out is to experiment, to make sure the switches will work.
Key indicators of incompatibility will be buzzing from the device or the bulb, and the bulb failing to light up properly.
Dimmable CFLs are available, but these tend to be quite expensive. The only other alternative would be to replace dimmer switches with conventional ones.
I've been using 100-watt incandescent bulbs, how do I know what CFL bulb to buy?
When replacing an old-fashioned bulb with a CFL bulb, you need to use the one to five ratio . For example, if you are replacing a 100-watt incandescent bulb, a CFL bulb of 20 watts is required, (CFLs are commonly available up to 23 watts and can be found as low as 5 watts).
|Old bulb||New low energy bulb|
Is LED lighting more energy-efficient than low energy light bulbs?
LED lighting (LED stands for light emitting diode) has a possible future potential to be more efficient than compact fluorescent lighting. LED lights also have a longer life - they can last up to 20 years, and they have the advantage of reaching full illumination almost immediately, as well as being very compact.
The problem at the moment though is that the quality of the light given is not good enough for general indoor lighting. They are a good replacement for low voltage halogen bulbs, and are an option in your garden, for decorative and even security lighting.
Currently, for general indoor lighting, compact fluorescent light bulbs are definitely your best option.
Free energy saving light bulbs
If you're loooking for free energy saving light bubls expect to be disappointed. Unfortunately while you may be offered discounted and subsidised bulbs and despite the fact that they're getting cheaper all the time, we're yet to come across any free energy saving light bulbs.
- Carbon Footprint What is a carbon footprint, how can it be measured, and what can you do to reduce your carbon footprint?
- Free Energy Saving Tips Saving energy is a great way to save money
- Standby Savers Do you leave your appliances on standby instead of turning them off?
Take back control of your energy bills with uSwitch!
We make it easy to compare and save up to £512